The use of door closer is very common, especially at the entrance of stairs in the office area. You can often see its figure. How to install the door closer?
1、Measure the screw holes of the door closer and drill the corresponding holes with an electric drill.
2、Face the door closer to the hole drilled and lock it with screws.
3、After installing the door closer, install other parts.
4、Install another device of the door closer on the door panel so that the two components are sleeved together, and then lock the screws.
What are the installation methods of door closer
1. Parallel installation
For this way, it is mainly to install the product on the door, and on the inner side of the sliding door, it is suitable to be used in some places where the door frame is narrow or there is almost no door frame. At the same time, because there is no prominent connecting rod and rocker arm, it will be better in appearance.
2. Standard installation
It is mainly suitable for places where the door frame is relatively narrow and there is no sufficient area to place such products. For this construction method, even if the door is opened to the maximum angle, the door closer will not hit any objects. It is usually installed on the door and the support is on the door frame.
3. Hide installation
This method is more suitable when the closing force is small. At the same time, because there are no exposed parts, it will be relatively beautiful. However, during construction, the process will be more complex. Therefore, it is best to invite professionals to carry out the construction to increase the smoothness of the construction.
The above is about how to install the door closer and what are the installation methods of the door closer