Because the door closer has not been widely used at present, especially in families, few people will install it, so many people are still not very clear about its installation and debugging. Although it seems very simple, if the installation or debugging is not good, there will be a great security risk. Now let's talk about the specific process of installation and debugging of the door closer.
1、 Determine the position of the screws to be installed according to the position indication on the installation template, and then start drilling and tapping.
2、 Next, use the screws to install the closed door body
3、 Install the fixed connection seat
4、 Install the drive plate with the screws
5、 Adjust the adjusting rod to a 90 degree position with the door frame, and then connect the connecting rod with the drive plate.
6、 Install the plastic cover, because the plastic cover can be used to catch the hydraulic oil leaked from the door closer
7、 After the installation, we need to check whether each fixed screw is firm, and there should be no loose or insecure appearance.
8、 Open the door to the maximum opening position, and then check whether the hinged arm of the door closer collides with the door or the door frame or has friction.
After the above eight installation steps, a complete door closer is installed and debugged. During the installation process, the most important thing is to check whether our screws are firm. If they are not firm or loose, they will have a certain impact on the buffer of the door closer, and there are potential safety hazards.